Made Antenna Omni WiFi 2.4 GHz

Here is an example in making the 2.4 GHz WiFi antenna.
For readers who wish to build an antenna HOTSPOT this should be tested in order to push the price compared with buying a factory-built antenna.
A. Material

1. Coaxial RG 6
2. Pip paralon ¾ inc
3. Pip copper AC ¼ inc x 0,56
4. Connector type M40-F 1 item
5. Tin solder
6. Lem stick
7. Copper plate
8. Rivet nails

B. Tools

1. Hand drill machine
2. Tang rivet
3. Solder
4. Glue Gun
5. Tang combination
6. Tang long nose
7. Tang cut
8. Ruler roll 3 M

C. Job Picture
1. Driven / horn
2. Omni antenna series

D. Step Work
1. Driven / Horn

• Cut Pipe copper AC berdiameter 1 / 4 “along the 47 mm
• Cut Coaxial RG 67mm round 6, and then dispose of the skin outside
• Skin peeled in at the end of the second Coaxial RG 10 mm round 6
• Enter paring 6 RG Coaxial copper pipe into the AC
• Make work point 1.a s.d. 1.d point of 25 times.
• Connect the results of 1.e point to the way in solder and in selingi grown between the cable and cable positive, look at pictures

So do the job above all connected

• After all all connected, at the end of a driven / horn installed Stub Stub’s edge and one in M40 plug connector type-F, note the picture

2. Finishing

• Cut pipe pralon throughout the 150 cm
• Enter driven / horn that has been made in the point 1 into the pipe pralon and M40-type connectors F outside of pralon it. (see the image of)
• Close the top of the cover / hubcap pralon
• Use the glue gun glue type connector M40-F in order to stick with a strong edge in pralon.